Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Paul Hochköpper GmbH & Co. KG
Postfach 1727 • D-58467 Lüdenscheid • Tel.: +49 (0)2351 185-0 • Fax: +49 (0)2351 27666 • e-mail: peha@peha.de • Internet: www.peha.de
Installation and Operating Instructions
Easyclick plug & socket receiver PLUS
Art.no.: 4571 FU-EP ST / CH
1. General
1.1 Application
This receiver can switch electric loads, like lamp bulbs and HV-halogen lamps, on
and off. The receiver is operated with Easyclick transmitters (radio signal).
Before use, the transmitters must be assigned to the receiver (max. 32 receivers).
Every transmitter can control an unlimited number of receivers.
Note: Read through the operating instructions carefully before putting the unit into
service.
1.2 Warranty conditions
These operating instructions are an integral part of both the device and our terms
of warranty. They must be handed over to the user. The technical design of the
appliance is subject to change without prior notification. PEHA products are manuf-
actured and quality-checked with the latest technology according to applicable nati-
onal and international regulations. Nevertheless, if a product should exhibit a defect,
PEHA warrants to make remedy as follows (regardless of any claims against the
dealer to which the end-user may be entitled as a result of the sales transaction):
In the event of a justified and properly-established claim, PEHA shall exercise its
prerogative to either repair or replace the defective device. Further claims or liability
for consequential damage are explicitly excluded. A justifiable deficiency is one in
which the device exhibits a structural, manufacturing, or material defect that makes it
unusable or substantially impairs its utility at the time it is turned over to the end-user.
The warranty does not apply to natural wear, unintended usage, incorrect connec-
tion, device tampering or the effects of external influences. The warranty period is
for 24 months from the date of purchase by the end-user from a dealer and ends not
later than 36 months after the device's date of manufacture. German law shall be
applicable for the settlement of warranty claims.
1.3 Disposal of the device
The device must be disposed of in compliance with the laws and standards of the
country in which it is operated!
1.4 Conformity declaration
PEHA products may be sold and operated in EU countries as well as in CH, IS and
N. PEHA herewith declares that the receiver (4511 FU-EP ST / CH) is in compliance
with the fundamental requirements and other relevant provisions of R&TTE Directive
1999/5/EC. The conformity declaration is available on the Internet at the following
address: www.peha.de/ServiceDownloads.aspx.
2. Safety
CAUTION! Danger of electrical shock!
The housing contains current-carrying components.
Contact can lead to personal injury!
All work on the mains network and the device may only be done by
an authorised electrician.
• Disconnect power supply from the device
• Check that the device is powered off.
• Close the housing securely before applying power.
This device is only intended to be used for its stated application. Unauthorised con-
versions, modifications or changes are not permissible! This device may not be used
in conjunction with other devices whose operation could present a hazard to perso-
ns, animals or property.
3. Technical specifications
General data
Transmit frequency
868,3 MHz
Power supply
230V~ / 50 Hz
Ambient temperature
+ 10 to + 40°C
Storage temperature
- 20 to + 60°C
Test specifications
EN 60669-2-1
Identification
CE
Protection type
IP20
4571 FU-EP ST CH (Rev02_090401)
GB
Permissible loads
Range in buildings
Masonry
Reinforced concrete
Plasterboard/wood
Note: The strength of the radio signal between sender and receiver decreases with
increasing distance. The visually unobstructed range is about 30 m in passageways
and 100 m in open rooms. The range can be increased through the use of an Ea-
syclick repeater.
4. Commissioning
4.1 Safety notices
• Observe the operating instructions for the transmitter used.
• For permitted load types, observe the max. load rating.
• Do not use outdoors (indoor use only).
• Avoid extreme temperatures, moisture and jarring.
• Use only in CE approved electrical outlets.
• Do not use in extension cord outlets.
• Do not connect multiple plug & socket receivers into one another.
• Do not insert foreign objects into the plug & socket outlet.
• Do not connect devices into the outlet which could cause fire or other types of
damage in unattended operation (e.g. heaters or irons).
• Remove the plug & socket receiver from the outlet before cleaning it; clean with a
slightly moistened cloth.
• Do not use aggressive cleaning agents for cleaning.
4.2 Commissioning
• Plug the plug & socket receiver into a conventional CE electrical outlet.
• Plug the load into the load output socket.
• Program the receiver (see Point 5).
126387-01
Incandescent lamps (Ω)
2500 W
HV-halogen lamps
1250 W
20 m, through 3 walls max.
10 m, through 1 wall/ceiling max.
30 m, through 5 walls max.
Load output
can be switched
LED display
Learn mode: LED = red
Function programming.: LED = green or orange
LRN/SET button
Learn mode and function programming
CLR/MODE button (side)
Delete all transmitters and parameter setting
GB - 1
Werbung
