Delay Time; Sound Edit - Samsung HT-D350 Bedienungsanleitung

Setup
Settings
Speaker Setting
•
For the Front, the mode is set to Small.
•
For the Subwoofer, the mode is set to Present.
•
For the Center and Surround, you can switch the
mode to Small or None.
- Small : Select this when using the speakers.
- None : Select this when no speaker is
connected.
✎
NOTE

The speaker mode may vary depending on the
Dolby Pro Logic and Stereo settings.

Sound Edit

You can adjust the balance and level for each speaker.
Settings
Front Bal.
Surround Bal.
Center Level
Surround Level
SW Level
Press the ▲▼ buttons to select and adjust the
desired speaker.
Press the ◄► buttons to adjust the settings.
Adjusting Front/Surround Bal.

You can select between 0 and -6.

The volume decreases as you move closer to –6.
Adjusting Center/Surround/Subwoofer Level

The volume level can be adjusted in steps from
+6dB to –6dB.

The sound gets louder as you move closer to +6dB
and quieter as you get closer to -6dB.
20
English
HT-D350-XU_ENG-1228.indd 20 HT-D350-XU_ENG-1228.indd 20
Speaker Size
►
Sound Edit

Delay Time

Test Tone : Off
Select Return
mMove " Select ' Return
Sound Edit
dB L R dB
dB L R dB
dB
dB
dB
<Change " Select ' Return
mMove " Select ' Return
Delay Time
If the speakers cannot be placed at equal distances from
the listening position, you can adjust the delay time of the
audio signals from the Center and Surround speakers.
You can also set the Test Tone in this mode.
Setting up the Speaker Delay Time
When 5.1CH Surround Sound is played, you can
enjoy the best sound if the distance between you
and each speaker is the same.
Since the sounds arrive at the listening position at
different times depending on the placement of
speakers, you can adjust this difference by adding a
delay effect to the Center and Surround Speakers.
Settings
Delay Time
Front
Center
Surround
Subwoofer
Test Tone
<Change " Select ' Return
mMove " Select ' Return
Test Tone
Settings
Speaker Setting
Speaker Size
Sound Edit
Delay Time
Test Tone
mMove " Select ' Return
Use the Test Tone feature to check the speaker
connections.
• Press the ◄► buttons to select On.
The test tone will be sent to Front Left ➞ Center
•
➞ Front Right ➞ Surround Right ➞ Surround
Left ➞ Subwoofer in order.
To stop the test tone, press the ENTER button.
: 00ms
: 10ms
: Off
: On
►
" Select ' Return
2011-12-28 2011-12-28 3:10:18 3:10:18