How To Use - Vevor Rtd-10-50In.lbb Benutzerhandbuch

4.2 Model:RTD-10-70in.lb
1) Range and Precision: 10~70in.lb (±5%)FS
2) Increment : 1 lbf.in
3) Driver size: 1/4inch
4) Screwdriver bit Material and QTY: S2/CrV ;13pcs ;
5) Breaker bar: 1pcs
6) 1/4" to 1/4" adapter: 1pcs
4.3 Model:RTD-20-70in.lb
1) Range and Precision: 20~70in.lb (±5%)FS
2) Increment : 2 lbf.in
3) Driver size: 1/4inch
4) Screwdriver bit Material and QTY: S2/CrV ;16pcs ;
5) Extension rod: 1pcs
6) Breaker bar: 1pcs

5 How To Use

Step 1:
Set the torque value of the screwdriver according to the torque required when the
fastener is tightened. When the torque value is preset, hold the hand part first, hold
the hand wheel with the other hand, and move it to the straight circle. Press the
direction and then adjust the hand-wheel clockwise to make the linear scale ring.
Let the value of the main scale line and the sub-scale line reach the required
torque value, then release the adjustment hand-wheel and the preset torque value
is completed.
Step 2:
According to the head form of the fastener, select the batch head from the
accessory and insert it into the hexagonal joint of the screwdriver (if there is no
suitable batch head in the attachment, the batch head can be processed by itself.
The size of the hex joint is as shown in the above figure. Show).
Step 3:
Install the batch head of the corresponding specification on the
screwdriver, align the bit to the fastener with the handle, and turn the
- 4 -