iStorage DATASHUR PRO2 Benutzerhandbuch Seite 28

33. How to set the User PIN Brute Force Limitation
Note: The User PIN brute force limitation setting is defaulted to 10 consecutive incorrect PIN entries when
32. How to set the User PIN Brute Force Limitation
the drive is either completely reset, brute forced or the self-destruct PIN is activated.
The brute force limitation for datAshur PRO
attempts from 1 to 10 consecutive incorrect PIN entries.
To confi gure the User PIN brute force limitation, fi rst enter the "Admin Mode" as described in section 5. Once the drive is in Admin
Mode (solid BLUE LED) proceed with the following steps.
1. In Admin mode, press and hold down both
7 + 0 buttons
2. Enter the number of attempts for the brute force limitation (between 01-10), for example enter:
• 01 for 1 attempt
• 10 for 10 attempts
3. Press the SHIFT ( ) button once
Note: When the datAshur PRO
time the drive can accept instructions via the keypad allowing it to be confi gured with a host of security features. If no key event
happens within 30 seconds, the datAshur PRO
RED LED which then fades out to the Idle state (all LEDs off).
To immediately exit Admin Mode (solid
LED switches to a solid
must fi rst be in the idle state (all LEDs off) before an Admin/User PIN can be entered.
#28
2
User PIN can be reprogrammed and set by the administrator. This feature can be set to allow
2
is in Admin Mode, the
2
will exit Admin mode automatically - the solid
BLUE LED), press and hold down the SHIFT (
RED LED which then fades out to the Idle state. To access the drive contents (data), the datAshur PRO
Solid BLUE
LEDs blinking together
Blinking
solid GREEN
BLUE
successfully confi gured
BLUE LED will remain on and solid for 30 seconds only, during which
www.istorage-uk.com
LED will change to GREEN
GREEN and BLUE LEDs will switch to a
LED for a second and then to a solid
LED indicating the brute force limitation was
BLUE LED switches to a solid
) button for a second - the solid
and BLUE
BLUE
2