iStorage DATASHUR PRO2 Benutzerhandbuch Seite 23

26. How to Confi gure an Admin PIN after a Brute Force attack or Reset
It will be necessary after a Brute Force attack or when the datAshur PRO
be used.
PIN Requirements:
• Must be between 7-15 digits in length
• Must not contain only repetitive numbers, e.g. (3-3-3-3-3-3-3)
• Must not contain only consecutive numbers, e.g. (1-2-3-4-5-6-7), (7-8-9-0-1-2-3-4), (7-6-5-4-3-2-1)
2
If the datAshur PRO has been brute forced or reset, the drive will be in standby state (solid
ceed with the following steps.
1. In Standby state (solid RED
down both SHIFT ( ) + 1 buttons
2. Enter New Admin PIN and press KEY ( )
button
3. Re-enter the New Admin PIN and press
KEY ( ) button
Note: When the datAshur PRO
time the drive can accept instructions via the keypad allowing it to be confi gured with a host of security features. If no key event
happens within 30 seconds, the datAshur PRO
RED LED which then fades out to the Idle state (all LEDs off).
To immediately exit Admin Mode (solid
LED switches to a solid RED
must fi rst be in the idle state (all LEDs off) before an Admin/User PIN can be entered.
27. Setting the Unattended Auto-Lock Clock
To protect against unauthorised access if the drive is unlocked and unattended, the datAshur PRO
automatically lock after a pre-set amount of time. In its default state, the datAshur PRO
feature is turned off. The Unattended Auto Lock can be set to activate between 5 - 99 minutes.
LED), press and hold
2
is in Admin Mode, the BLUE
2 will exit Admin mode automatically - the solid
BLUE LED), press and hold down the SHIFT (
LED which then fades out to the Idle state. To access the drive contents (data), the datAshur PRO
www.istorage-uk.com
2
has been reset to confi gure an Admin PIN before the drive can
RED
Solid RED LED will change to blinking
solid BLUE LEDs
Blinking GREEN
a single GREEN
GREEN and solid
Blinking GREEN
to BLUE LED rapidly blinking for a few seconds and
then to a solid
was successfully confi gured.
LED will remain on and solid for 30 seconds only, during which
) button for a second - the solid
2 Unattended Auto Lock time-out
LED). to confi gure an Admin PIN pro-
GREEN
and solid BLUE LEDs will switch to
LED blink and then back to blinking
BLUE LEDs
LED and solid BLUE LED change
BLUE LED indicating the Admin PIN
BLUE LED switches to a solid
2 can be set to
and
BLUE
2
#23