BYSTRO RIO BYS-WHRIO90-SS Montageanleitung Seite 30

Clean air function
1. Press keys 2 and 5 simultaneously, the display will show 1.
2. Press key 5 to select the desired speed.
3. Press keys 2 and 5 simultaneously again.
During programming, if the function is not confirmed within a few seconds,
programming is exited.
Press any key except key 1 to deactivate the setting.
Switching the lighting on and off
Press key 1 to switch the lighting on and off.
Changing the intensity of the lighting (optional)
1. Press key 1 to switch the lighting on.
2. Press key 1 for a long time to change the intensity of the lighting.
3. Press key 1 to switch off the lighting.
Variation of lighting colour temperature (optional)
1. Press key 1 to switch the lighting on.
2. Press keys 1 and 3 simultaneously to make the lighting warmer, until the
3. Press keys 1 and 5 simultaneously to make the lighting cooler, until the
4. Press key 1 to switch off the lighting.
Courtesy lighting (optional)
Press key 1 for more than 2 seconds to switch the courtesy lighting on and off.
Cleaning of the filters
Grease filter cleaning indicator
After 100 hours of using the hood, a periodic acoustic signal is emitted and the
Ξ symbol flashes in the display. The grease filter must be cleaned.
Ÿ
Carbon filter cleaning indicator
After 200 hours of use of the hood, a periodic acoustic signal is emitted and the
symbol C flashes in the display. The carbon filter must be cleaned or replaced.
Ÿ
Activating the carbon filter cleaning indicator
In vacuum mode, the carbon filter cleaning indicator is not active. If the hood is
used in filter mode, the carbon filter cleaning indicator must be activated.
Ÿ

22 EN
The Clean Air function is activated.
The hood will be switched on for 10 minutes every hour for the next 24
hours at the flashing speed shown in the display.
After 10 minutes the hood switches off automatically.
The lighting is switched on at maximum brightness.
maximum warm light point is reached.
maximum cold light point is reached.
To reset the cleaning indicator, press key 2 twice with the hood switched off.
A confirmation sound will be heard and the Ξ symbol will appear in the
display.
To reset the cleaning indicator, press key 2 twice with the hood switched off.
A confirmation tone sounds and the symbol C appears in the display.
Press keys 2 and 6 simultaneously for 5 seconds, the symbol C will appear
in the display followed by an acoustic signal.
Do not set the hood to filter mode if it uses a plasma filter.