BYSTRO RIO BYS-WHRIO90-SS Montageanleitung Seite 26

suitable place that meets installation requirements.
WARNING: Failure to install the screws or fixing device in
Ÿ
accordance with these instructions may result in electrical
hazards.
Do not use adhesives to fix the appliance.
Ÿ
The minimum distance between the hob surface on which
Ÿ
the pans stand and the lower part of the appliance shall be
at least 65 cm, unless otherwise specified in the installation
instructions for the appliance or hob.
The discharge of air must comply with local authorities
Ÿ
regulations.
Ensure good air ventilation in the room where the
Ÿ
appliance is installed to avoid the backflow of gases into
the room from appliances burning gas or other fuels,
including open fires.
Make sure that the ventilation openings are not blocked
Ÿ
and the air collected by the appliance is not conveyed into
a duct used to exhaust smoke and steam from other
appliances (central heating systems, thermosiphons, water
heaters, etc.).
When the appliance operates with other appliances the
Ÿ
maximum vacuum generated in the room should not
exceed 0,04 mbar.
Make sure not to cause damage to the mains cable.
Ÿ
Contact our Authorised Service Centre or an electrician to
change a damaged mains cable.
If it not fitted with a plug (direct mains connection) or if the
Ÿ
plug is not located in an accessible area, after installation,
apply a double pole switch in accordance with standards
which assures the complete disconnection of the mains
under conditions relating to over-current category III in
accordance with installation instructions.
lf the appliance is connected directly to the power supply,
Ÿ
the electrical installation must be equipped with an
isolating device that allows to disconnect the appliance
from the mains at all poles. Complete disconnection must
18 EN