Method Of Use - Cangaroo Delicate Gebrauchsanweisung

15. If the vacuum and pressure cause you discomfort or pain, stop using the breast pump by
firstly putting finger between the breast and silicone massage pad and the remove the pump
from your breast.
16. WARNING! This product is intended for personal usage and it is not intended for the
usage of other mothers.
17. The breastmilk bottle in the set is an integral part of the breast pump. For the purposes of
this product use only this bottle and only for the breast milk collected with this pump.
FOR YOUR CHILD'S SAFETY AND HEALTH
WARNING!
•Always use this product with adult supervision.
•Never use feeding teats as a soother.
•Continuous and prolonged sucking of fluids will cause tooth decay.
•Always check food temperature before feeding.
•Keep components not in use out of the reach of children.
•Throw away at the first signs of damage or weakness.
•Inspect carefully before each use. Pull the soother in all directions. Throw away at the first
signs of damage or weakness.
•Do not leave the soother to direct sunlight or any other heat source, or in
disinfectants (sterilizing solution) longer than recommended as this can weaken the
teat.
II. BASIC PARTS OF THE MANUAL BREAST PUMP – FIGURE PD
SEE FIGURE PD: A. Cover of the silicone pad/ bottle stand; B. Silicone massage pad; C. Silicone diaphragm and
stem for the handle; D. Handle; E. Pump body; F. Silicone valve; G. Bottle ring with sealing disc.
III. ASSEMBLY OF THE MANUAL BREAST PUMP
Make sure that you have cleaned well and sterilized all the parts of the manual breast pump before starting
its assembly. Wash your hands thoroughly! Follow exactly the instructions and sequence for assembling the
product, described in the text and images hereafter attached.
1. Step 1: With clean hands put the silicone valve (F) on the pump body (E).
2. Step 2: Attach to the pump body the silicone sealing ring. Then fix the body to the bottle ring and the so
assembled part attach to the milk bottle.
3. Step 3: Attach the silicone diaphragm with the stem for the handle in the upper part of the pump body and
with fingers seal it to the body. The diaphragm should fit firmly to the pump body.
4. Step 4: Fix the handle on the pump (D) to the stem and attach it to the intended for it stand on the pump
body. Push carefully until you hear a clicking sound showing the fixing of the handle. After that put the cover
for the pump body over the silicone diaphragm.
5. Step 5: Attach the silicone massaging pad to the pump body by gently pushing its inner end as farther as
possible and make sure that it fits ideally to all sides of the funnel of the pump body.
In order the breast pump to be stable, you can put it on the bottle stand. When the pump is not being used,
this stand can be used as a cover for the silicone pad.
6. Step 6: After assembling the breast pump, it should be looking as the photo provided.
IV. METHOD OF USE
A. WHEN YOU CAN USE THE BREAST PUMP:
1.If it is possible.
•Only if you have sufficient milk secretion and normal time for breastfeeding.
•The use of the breast pump may begin usually two or four weeks after the birth of Your baby until you set a
graphic of expressing the breast milk and the breastfeeding. Unless if Your doctor/ health advisor hasn't
9