Werbung
- Select a high gear and raise your speed gradually and slowly to the
desired speed. Hold it for a second, then slow down and stop.
(You should of course slow down and stop as traffic conditions dictate. The unit
will not exit from learning mode until you stop the engine. It records the
highest speed as long as "H" is flashing on the display.)
- When done, you can save the setting and exit from learning mode two
ways: stop the engine or turn ignition off.
8. Deactivating the SL and HSW features
If you wish to deactivate or re-program the Shift Light or High Speed Warning
features, perform the following steps:
- Park the bike and turn ignition On
- Start the engine in neutral, and warm the engine if necessary.
(Do not move the bike, otherwise you will need to restart the sequence.)
- Gradually and very slowly increase the RPM, and keep it in the range
3-4 times of your idle speed (usually 3000-4000 RPM).
As a guide, the display will show a "¯" (top horizontal bar) sign when
you keep the RPM in this range.
- Hold the RPM for about 5 seconds, until "C" (Clear) is flashing on the
display.
- Now, if you wish to deactivate both features, stop the engine or turn the
ignition Off.
Otherwise, continue with chapter 6 or 7.
Note: you can not activate and use both features at the same time. If you
program one, it will clear the previous setting.
9. Warranty
The unit is completely sealed and epoxy-encapsulated, which gives the maximum
protection for the internal parts from shock, vibration and water ingress.
To ensure trouble-free operation from the start, all units have been extensively
tested prior to shipment.
Our dealers offer a 30-day money-back guarantee on HealTech products if the
product does not fulfil your expectations. (All parts must be returned in original
condition for full refund.)
Furthermore the product is covered by our 2-year replacement warranty from
the date of purchase.
- 4 -
(if it is already on, cycle the ignition key).
Web:
www.gi-pro.net
Email:
support@healtech-electronics.com
Werbung
