Werbung
5. Reset
If some gears are not indicated correctly, reset the unit and set it up again.
- Have the engine stop switch in OFF position.
- Turn the ignition key ON and immediately turn it off while the GIpro
display is counting up and is showing "3,
Repeat this step 5 more times.
- On the next power up, the display will count backwards
The memory is now cleared and you can perform the Setup procedure.
Note: If you perform the Reset procedure, it will set the device to factory default
condition. The Shift Light and High Speed Warning features will also be cleared.
6. Shift Light
If you wish, you can program the device to indicate when the desired RPM is
reached.
The unit will rapidly flash a "U" (Up) once you exceed the pre-set RPM. The
feature is intelligent, as it does not operate in top gear. To activate the feature:
- First, perform the deactivation steps as per chapter 8.
- When "C" (Clear) is flashing, raise the RPM very slowly.
- The display will begin flashing a "U" sign, indicating that the Shift Light
learning is in progress. The unit learns the highest RPM.
- Raise the RPM gradually and very slowly to the desired RPM, and hold it
for a second. Release the throttle.
- When done, you can save the setting and exit from the learning mode in
three ways: start riding, stop the engine or turn ignition off.
7. High Speed Warning
If you wish, you can program the device to warn you when your speed exceeds a
set limit.
The unit flashes the actual gear
way you can still see the gear position. To activate the feature:
- First, perform the deactivation steps as per chapter 8.
- When "C" (Clear) is flashing, select first gear and start riding.
- The display will be flashing an "H" sign, indicating that the HSW
learning is in progress. The unit learns the highest SPEED.
4
or 5".
"1
to 5/6" above the pre-set speed limit. This
to 1").
("6
- 3 –
Werbung
