ProBreeze PB-H05 Bedienungsanleitung Seite 6

TIMER FUNCTION
― ―
Timer
Triangluar Point
Segments
(Figure 1)
The heater can be set to turn ON and OFF at the time you want. Before setting a timer, the clock
must be set to the correct time. Turn the dial clockwise until the triangular pointer is pointing at
the correct time. Do not turn the clock anti-clockwise. There are 96 segments around the dial –
each representing 15 minutes of the day.
Setting the Timer
1. Plug in the heater.
2. Set the power and temperature to the desired settings.
3. Turn the dial clockwise to set the clock to the current time of the day.
4. Push the segments inwards for the period you want the heater off and leave the segments
outwards for the period you want the heater on. For example, the diagram above (Figure 2)
shows the heater will turn on between 1 AM to 3 AM.
5. Once you have set the segments for the desired heating period, the heater will cycle on and
off according to these settings.
6. Once unplugged, the heater timer will stop and will need to be reset.
Note: When you first use the heater, all 15-minute segments should be outwards. To begin
using the timer, push the segments inwards that represent the time of the day you want the
heater to remain off and leave the segments outwards that represent the time of the day
you want the heater to work. The heater will switch off again after that period has elapsed.
10 of 76 | English
CLEANING AND STORAGE
― ―
Current Time 8:00AM
8 Segments Outwards
(Figure 2)
•
•
•
•
•
•
WARNING: ALWAYS TURN THE HEATER OFF, UNPLUG THE
POWER CORD FROM THE ELECTRICAL OUTLET AND ALLOW
THE APPLIANCE TO COMPLETELY COOL DOWN BEFORE
HANDLING OR CLEANING IT.
WARNING: ALLOW THE HEATER TO COOL DOWN FOR 2
HOURS (120 MINUTES) BEFORE CLEANING.
CAUTION: DO NOT ALLOW WATER OR OTHER LIQUIDS TO
RUN INTO THE INTERIOR OF THE HEATER, AS THIS COULD
CREATE A FIRE AND/OR ELECTRICAL HAZARD.
CAUTION: DO NOT USE ANY ABRASIVE CLEANERS OR
SOLVENTS, AS HEATER DAMAGE WILL OCCUR.
Do not attempt to clean the heater in any other way than
that detailed by the manufacturer.
Clean the exterior surface of the heater by wiping it with
a soft, damp cloth. Dry the heater with a soft clean cloth.
Clean the air inlet and outlet grills regularly with a
vacuum cleaner, using the brush attachment to avoid
any dust build-up.
To store your product out of season, we recommend
using the original or similar size box.
Do not kink or wrap the power cord and plug around the
appliance, as this may cause the insulation to weaken or
split, particularly where it enters the appliance.
Store the heater in a safe, clean and dry place, away
from direct sunlight and out of reach of children when
not in use.
English | 11 of 76