Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
Note: If you cut tall grass in a single pass, you could adversely affect the lawn.
WARNINGS:
–
Dirt and corrosion can damage the blade, affecting the performance of the tool. Fig. 12
–
Do not touch the blade.
–
Avoid, as much as possible, using the tool in very hot weather.
–
Cut the lawn with the corresponding blade.
Turn the tool on after adjusting the cutting height and hold it so that the bottom of the tool
rests on the ground. Gently move it forward. Fig. 13
4. CLEANING AND MAINTENANCE
Cleaning
WARNING: Before carrying out any maintenance or cleaning task on the tool, make sure
that it is switched off and that the battery has been removed.
–
After using the hedge trimmer, clean the dust from both sides of the blade with a wire
brush, then wipe it with a dry cloth and apply a few drops of lubricating oil. Fig. 14
–
Clean the dust off the tool with a dry or damp cloth with a little soap after each use.
–
Never use gasoline, benzine, thinner, alcohol or similar products to clean the tool. Doing so
may cause discoloration, deformation or cracking.
Blade maintenance
–
Before using the hedge trimmer, or if it has been in use for more than one hour, apply low
viscosity lubricating oil to the blade.
5. TROUBLESHOOTING
The tool is maintenance-free. If you nevertheless detect a fault, do not attempt to repair the
tool by yourself. Contact the official Cecotec Technical Support Service.
6. TECHNICAL SPECIFICATIONS
Product reference: EU01_102262
Product: TitaniumSword 2120 Hand XL
136
TITANIUMSWORD 2120 HAND XL
ORIGINAL INSTRUCTIONS
Werbung
