Troubleshooting; Remote Control Does Not Operate - Octagon SF 1008 HD - INTELLIGENCE Bedienungsanleitung

Troubleshooting

Problem Solution
Check the main power cable and check that it is plugged into a
Does not display any message
suitable power outlet.
on the front panel.
Check the STB main power switch 'ON' at the rear of the STB.
See 'Does not display any message on the front panel' above.
To match the STB system with your TV system (PAL/NTSC),
press V.Format button until a picture is displayed.
Check the video output port is firmly connected to the TV or
VCR.
If you are using the RF output, check that the RF lead is
connected firmly to the STB and TV/VCR.
No Picture
Check that you have selected the Video Input on your TV.
Press the STB button on the remote to assure you are
controlling the STB and no other device with the remote.
Check the brightness level of the TV.
Check the resolution that your TV supports, and set the proper
resolution with the remote Resolution button to obtain a
picture.
See 'No Picture' above.
Poor picture quality
Check the signal level, if this is low then tries adjusting the
alignment of your dish.
See 'No Picture' above.
No Sound
Check the volume level of the TV and STB.
Check the Mute status of the TV and STB.
Remote Control does not
Point remote control directly towards the STB.
operate Check and replace batteries.
Check the LNB ; Replace the LNB if necessary.
Check the cable from the LNB.
Check the position of the dish; realign dish if necessary.
No or Bad Signal
If you are using a DiSEqC 1.0 switch, check that you have
connected and programmed the LNBs to the correct
connections on the switch.
Check the 'Signal Level' and the 'Signal Quality' .
43