Canon i-SENSYS MF631Cn Erste Schritte Seite 80

Appendix
En
Maintenance and Inspections
Clean this machine periodically. If dust
accumulates, the machine may not operate
properly. When cleaning, be sure to observe the
following. If a problem occurs during operation,
see Troubleshooting. If the problem cannot be
resolved or you feel the machine requires an
inspection, see When a Problem Cannot Be
Solved.
WARNING
Before cleaning, turn OFF the power and
•
unplug the power plug from the AC power
outlet. Failure to do so may result in a fire or
electrical shock.
• Unplug the power plug periodically and clean
with a dry cloth to remove dust and grime.
Accumulated dust may absorb humidity in the
air and may result in a fire if it comes into
contact with electricity.
• Use a damp, well wrung-out cloth to clean the
machine. Dampen cleaning cloths with water
only. Do not use alcohol, benzenes, paint
thinners, or other flammable substances. Do
not use tissue paper or paper towels. If these
substances come into contact with electrical
parts inside the machine, they may generate
static electricity or result in a fire or electrical
shock.
Check the power cord and plug periodically
•
for rust, bent prongs, fraying, cracks, or
excessive heat generation. Use of poorly-
maintained power cord or plug may result in a
fire or electrical shock.
CAUTION
The inside of the machine has high-
•
temperature and high-voltage components.
Touching these components may result in
injury or burns. Do not touch any part of the
machine that is not indicated in the manual.
• When loading paper or removing jammed
paper, be careful not to cut your hands with
the edges of the paper.
Legal Limitations on the Usage of Your
Product and the Use of Images
Using your product to scan, print or otherwise
reproduce certain documents, and the use of
such images as scanned, printed or otherwise
reproduced by your product, may be prohibited
by law and may result in criminal and/or civil
liability. A non-exhaustive list of these
documents is set forth below. This list is intended
to be a guide only. If you are uncertain about the
legality of using your product to scan, print or
otherwise reproduce any particular document,
and/or of the use of the images scanned, printed
or otherwise reproduced, you should consult in
advance with your legal advisor for guidance.
• Paper Money
• Travelers Checks
Money Orders
•
Food Stamps
•
• Certificates of Deposit
• Passports
Postage Stamps (canceled or uncanceled)
•
Immigration Papers
•
• Identifying Badges or Insignias
Internal Revenue Stamps (canceled or
•
uncanceled)
• Selective Service or Draft Papers
• Bonds or Other Certificates of Indebtedness
Checks or Drafts Issued by Governmental
•
Agencies
• Stock Certificates
• Motor Vehicle Licenses and Certificates of Title
Copyrighted Works/Works of Art without
•
Permission of Copyright Owner
80
Safety-Related Symbols
Power switch: "ON" position
Power switch: "OFF" position
Power switch: "STAND-BY" position
Push-push switch "ON"
Protective earthing terminal
Dangerous voltage inside. Do not open
covers other than instructed.
CAUTION: Hot surface. Do not touch.
Class II equipment
Moving parts: Keep body parts away from
moving parts
[NOTE]
Some of symbols shown above may not be
affixed depending on the product.
v1602_00_en-GB
Laser Safety Label
Consumables
WARNING
• Do not dispose of used toner cartridges in
open flames. This may cause an ignition, and
result in burns or fire.
If you accidentally spill or scatter toner,
•
carefully wipe up the loose toner with a damp,
soft cloth and avoid inhaling any toner dust.
Never use a vacuum cleaner to clean up loose
toner. Doing so may cause a malfunction in
the vacuum cleaner or result in a dust
explosion due to static discharge.
CAUTION
• Keep the toner cartridges and other
consumables out of the reach of small
children. If toner is ingested, consult a
physician or poison control center
immediately.
• Do not attempt to disassemble the toner
cartridge. The toner may scatter and get into
your eyes or mouth. If toner gets into your
eyes or mouth, wash them immediately with
cold water and consult a physician.
If toner spills from the toner cartridge, avoid
•
inhaling it or allowing it to come into contact
with your skin. If the toner comes into contact
with your skin, wash immediately with soap. If
you inhale the toner or your skin becomes
irritated due to contact with the toner, consult
a physician or poison control center
immediately.
IMPORTANT
Handling the toner cartridge
• Be sure to hold the toner cartridge using the
handle.
"OFF"
Do not scratch the drum surface (
•
expose it to light. Do not touch the electrical
) or the toner cartridge memory
contacts (
).
(
a
b
• Do not remove the toner cartridge from this
machine or from the protective bag
unnecessarily.
The toner cartridge is a magnetic product. Do
•
not move it close to products susceptible to
magnetism including floppy disks and disk
drives. Doing so may result in data corruption.
Storing the toner cartridge
• Store in the following environment to ensure
safe and satisfactory use.
Storage temperature range: 0 to 35°C
Storage humidity range: 35 to 85% RH (relative
humidity/no condensation)*
Store without opening until the toner
•
cartridge is to be used.
When removing the toner cartridge from this
•
machine for storage, attach the protective
cover for the drum, and then place the
removed toner cartridge into the original
protective bag or wrap it with a thick cloth.
When storing the toner cartridge, do not store
•
it upright or upside down. The toner will
solidify and may not return to its original
condition even if it is shaken.
* Even within the storable humidity range,
water droplets (condensation) may develop
inside the toner cartridge if there is a
difference of temperature inside and outside
the toner cartridge. Condensation will
adversely affect the print quality of toner
cartridges.
Do not store the toner cartridge in the
following locations
Locations exposed to open flames
•
• Locations exposed to direct sunlight or bright
light for five minutes or more
• Locations exposed to excessive salty air
Locations where there are corrosive gases (i.e.
•
aerosol sprays and ammonia)
Locations subject to high temperature and
•
high humidity
) or
Bottom View
c