Pit Boss NAVIGATOR PB550G Montageanleitung Seite 10

15. INSTALLING THE GREASE BUCKET
Parts Required:
1 x Grease Bucket (#23)
Installation:
• Place the Grease Bucket on the spout hook on the end of the Main Barrel.
Ensure it is level to avoid grease spills.
• The unit is now completely assembled.
16. CONNECTING TO A POWER SOURCE
NOTE: Before plugging your Pit Boss
the temperature dial is in the OFF position.
STANDARD OUTLET
•
This appliance requires 220-240 volts, 50Hz, 250w service. It must be a
grounded plug.
IMPORTANT: Disconnect unit from power source when not in use.
IMPORTANT: Refer to Owner's Manual for Operating Instructions
10
into any electrical outlet, ensure
®
15
16
23