HOMCOM YH-20-1 Montageanleitung Seite 3

• WARNING: Do not use this heater in small rooms when they are occupied by persons
not capable of leaving the room on their own, unless constant supervision is provided.
• WARNING: To reduce the risk of fire, keep textiles, curtains, or any other flammable
material a minimum distance of 1 m from the air outlet
• The product cannot be used outdoors.
• Do not block the fireplace vent in anyway – it could overheat, causing a fire hazard.
• If there any faults or damages, unplug this unit immediately.
• If the unit has not been used for a while, ensure the power is off.
• Do not place the power cord in front of the fireplace.
• It is NOT recommended to use this unit on any type of carpet or rug.
• Dispose of packaging properly and carefully. Plastic materials can cause environmental
pollution.
• The product must be connected to the ground.
• The fireplace must be used under the AC voltage rating.
• This product is fitted with a thermostatic room temperature control.
Only for UK:
A. Do not use two high-power appliances in the same socket.
B. The plug needs to be plugged in fully.
C. Product socket cannot use extension cord.
The socket needs to be conformed to BS1363, the maximum withstand current value
needs to be greater than 13A.
Location of Controls
1.Thermostat control knob (TEMPERATURE SETTING)- Adjust to maintain room temperature.
ame sw c w
2 Fl i t i t
h - S
.
3.Heating setting: please press "
4.Heating setting : please press "
first press" ".
5.Flame dimmer control - Adjust to set flame intensity.
c e ame e ec n
h t a d p
s fl ff
" for 1000W.
"and "
ower on o
/ ff
.
" at the same time for 2000w(can not operate without
3