cecotec VISIONTOAST Bedienungsanleitung Seite 20

ENGLISH
- The toaster has three buttons to defrost frozen bread, reheat toasted bread, and toast
bagels on one side. In order to use these pre-set programmes, insert the bread into the
slot of the toaster and press STOP/START. Then, press the appropriate button. When the
defrost or bagel buttons are pressed, their indicator lights will turn on until the toasting
process is complete, or until STOP/START is pressed.
Warning
If bread gets stuck inside the toaster, unplug it, and let it cool down before trying to remove
the bread. Do not use a knife or any other sharp metal tool to do so, and do not touch the metal
parts inside the toaster. Make sure the bread slice is not too thick.
Tips
- Toasting is a combination of toasting and drying. Moisture levels differ in different bread
types, so toasting times may vary.
- For slightly dry bread, use a lower intensity.
- For fresh bread or wholemeal bread, use a higher intensity.
- Bread products with a very uneven surface will require a higher intensity. You can also
press the bagel button for perfect results.
- Thick bread pieces will take longer to toast, since more moisture must be evaporated from
the bread before toasting.
- When toasting raisin or fruit bread, remove any loose raisins from the surface of the bread
before placing the slices into the toaster. This will prevent pieces from falling into the
toaster or sticking on the wire in the slot.
4. TROUBLESHOOTING
Problem
The toaster does not work
Bread stuck in the slot
38
VISIONTOAST
Solution
Check the power connection and make sure the
plug it properly connected to the wall outlet. If
it does not work,
contact the official Cecotec Technical Support
Service.
Unplug the toaster and let it cool down. Then,
carefully remove the slice or slices from the
toaster. You may need to hold the toaster over
a sink and shake it gently to help loosen the
bread. Do not use metal objects to remove the
bread. Do not touch the metal parts inside the
toaster.
Bread slices cannot be seen over the slot
after toasting
The toast is too dark or too light
The toaster emits smoke
- If you experience problems with your toaster, check the issues below to make sure it
has been properly assembled before returning the appliance to your dealer or getting in
contact with the official Cecotec Technical Support Service.
- Make sure the toaster is safely plugged in.
- If you have recently cleaned the glass panel, make sure the panel is properly installed.
- To remove the glass panel, hold the toaster with one hand and lightly tilt it backwards.
Press the latch at the bottom, pull out the glass gently and clean it (Fig. 3).
- To reinsert the glass panel, lay the toaster on one side, hold the panel by the latch and
carefully slide it back in place until it clicks into place.
Important
When reinserting the glass panel, make sure that it clicks into place. Otherwise, the toaster will
not work. When the panel clicks into place, a safety switch is activated. Fig. 4.
5. CLEANING AND MAINTENANCE
- Unplug the toaster from the mains supply and allow it to cool down completely before
disassembling, cleaning, or storing it.
- Do not immerse the toaster, cord, or plug in water or any other liquid.
- Do not clean the inside of the toaster, as it may damage the heating elements.
- Do not use a metal scouring pad, abrasive materials, metal polish, harsh chemical cleaner,
or hard objects to clean any surface of the toaster.
- Wipe the outside surfaces of the toaster with a soft cloth or sponge and mild detergent.
- Remove the remaining crumbs after each use.
- Store the toaster in a clean, dry place when not in use. Make sure the appliance is clean and
dry, and unplugged from the power supply.
ENGLISH
If the bread slices are too small to be removed
from the toaster, unplug the toaster, and use
thin, heat-resistant tongs to remove the bread
from the toasting slot.
The selected intensity level is too high or too
low. Adjust it.
The selected intensity level is too high for that
type of bread. Press STOP/START to stop the
toasting process. Make sure the crumb tray
is empty and clean. Turn the unplugged unit
upside down over the sink and shake it gently
to remove crumbs.
VISIONTOAST
39