cecotec VISIONTOAST Bedienungsanleitung Seite 19

ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1. Glass viewing window
2. Toasting slot
3. Control panel
4. Intensity knob
5. Locking clamps of the glass panels
6. Crumb tray
7. Power button
8. Defrost button
9. Bagel button
10. STOP/START button
2. BEFORE USE
- This appliance is packaged in a way as to protect it during transport. Take the device out
of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the device when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
- Before using the toaster for the first time, it is important to perform a toasting process
without bread. Do so 4 or 5 times. Push the toasting lever down until it latches into place.
- When the toasting is finished, the toasting lever automatically springs up. The toaster is
now ready to be used with bread.
Warning:
A slight odour and smoke might appear when using the appliance for the first time. This is due
to manufacturing material residues and does not affect the operation of the appliance.
36
VISIONTOAST
3. OPERATION
1. Make sure the crumb tray is properly placed before use. It is located underneath the
heating elements and can be pulled out from the side of the toaster opposite to the
control panel. Fig. 2
2. Place the toaster on a clean, stable, heat-resistant surface. Make sure that no liquid or
flammable object is placed near the appliance.
3. Plug the toaster into an appropriate wall outlet.
4. Press the power button .
5. Select the intensity with the intensity knob. The intensity can be adjusted before or right
after pressing STOP/START. There are 7 intensity levels available for precise results.
Simply select the desired level according to your needs.
Please note
Select intensity 3 when using the toaster for the first time, then, adjust the intensity to your
liking for subsequent uses (use a lower intensity for thinner slices).
6. Place two bread slices side by side in the toasting slot and press STOP/START to start
toasting. The bread guides will automatically adjust to hold the bread in place and will
automatically lower down to toasting position.
7. To stop the toasting process at any time, press STOP/START.
8. While the bread is being toasted, you can watch the process through the glass panel.
9. The toast will automatically rise at the end of the programme.
Warning
Do not touch the metal parts of the toaster, as they will be hot after use.
10. If you want to toast more bread, allow the toaster to cool down for 15-20 seconds
between toasting cycles.
11. Press the power button to turn off the toaster when it is completely finished.
12. Unplug the appliance after use and let it cool down before cleaning or storing it.
Defrost button
Toasts frozen bread with an extended toasting cycle (can be combined with the bagel
programme).
Bagel button
Toasts bagels using only one side of the heating element.
STOP/START button
Press at any time to stop toasting.
ENGLISH
37
VISIONTOAST