Ego Power+ RTX2300 Bedienungsanleitung Seite 11

TROUBLESHOOTING
PROBLEM
ROTOCUT fails to start.
ROTOCUT stops while
cutting.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.com egopowerplus.com for full terms and conditions of the EGO Warranty policy.
CAUSE
◾
The battery pack is not properly
connected to the power head.
◾
The battery pack is depleted.
◾
The lock-off lever and trigger are
not depressed simultaneously.
◾
The motor is overloaded.
◾
The battery pack is too hot.
◾
The battery pack is disconnected
from the tool
SOLUTION
◾
Connect the battery pack to the power head.
◾
Charge the battery pack with an EGO charger
listed in this manual.
◾
Press the lock-off lever and hold it, then
depress the trigger to turn on the unit.
◾
The motor will recover when the load is
removed. For continuous work, decrease the
load on the ROTOCUT and avoid deep cutting;
instead, make progressively deeper cuts.
◾
Allow the battery pack to cool down naturally,
or air blow to speed up the cooling.
◾
Reconnect the battery pack.
ROTOCUT ATTACHMENT—RTA2300
EN
9