Replacing The Lamp - JUNO JCN08820S7 Benutzerinformation

20
Problem
Water flows on the rear plate
of the refrigerator.
Water flows into the refrigera-
tor.
Water flows on the floor.
The temperature in the appli-
ance is too low/too high.
If the advice does not lead to
the desired result, call the
nearest Authorized Service
Centre.

Replacing the lamp

CAUTION! Disconnect the plug
from the mains socket.
1. At the same time, with the fingers
expand up and down the transparent
Possible cause
The door is not closed cor-
rectly.
During the automatic defrost-
ing process, frost melts on
the rear plate.
The water outlet is clogged.
Food products prevent that
water flows into the water
collector.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
The temperature regulator is
not set correctly.
The door is not closed cor-
rectly.
The food products' tempera-
ture is too high.
Many food products are stor-
ed at the same time.
The door has been opened
often.
There is no cold air circula-
tion in the appliance.
cover and unhook it in the direction of
the arrows.
Solution
Refer to "Closing the door".
This is correct.
Clean the water outlet.
Make sure that food prod-
ucts do not touch the rear
plate.
Attach the melting water out-
let to the evaporative tray.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces-
sary.
Make sure that there is cold
air circulation in the appli-
ance.