VEVOR JPS-08A Benutzerhandbuch Seite 4

operation.Remove the power plug from the socket first.
9) DO NOT disassemble the machine, except by professionals.
10) UNPLUG the power source while filling or emptying the tank.
11) DO NOT spray water or liquid over the device and the control panel.
12) DO NOT operate the cleaner without proper grounding.
13) DO NOT place the device on a soft surface, where the vents could be
blocked.
14) Upon completion of the cleaning cycle, turn the heater knob off and
isolate the machine from the power source.
15) Take care when adding or removing items from the cleaning tank as the
fluid is likely to be hot and displaced fluid can damage the internal
components .Any displaced fluid must be dried up immediately.
16)In the event of a malfunction/emergency,disconnect the power supply
by
removing the power plug from the electrical outlet.
17)When heating is required, the water level should not be less than 2/3
full
18)If the supply cord is damaged, it must be replaced by a special cord or
assembly available from the manufacturer or its service agent.
19)The connector must be removed before the appliance is cleaned and
that the appliance inlet must be dried before the appliance is used again.
20) This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:(1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
SAVE THESE INSTRUCTIONS
TO PREVENT SERIOUS INJURY AND DEATH FROM TIPPING:
1. DO NOT SIT OR STAND ON THIS ITEM.
2. When the machine is used several times continuously, in order to avoid
the damage and failure of the parts caused by overheating, the machine
will enter into a system of self-protection, it can be resumed after about 5
USE PRECAUTIONS
3