Gluceofine Blutzucker-Mess-System Benutzerhandbuch Seite 82

Troubleshooting
Message
82
Problem
Problem with the
Auto-coding label
The ambient
temperature is too low
The ambient
temperature is too high
The test result is lower
than 10mg/dL
The test result is higher
than 600mg/dL
Action Required
Please insert a new test strip and
perform your test again. If Er6 message
persists, please contact your local
representative. If blink with "Sun",
avoid to the direct sunlight and retest.
Place the blood glucose test meter
within the operating temperature
range for 10 minutes or more and
retest.
Place the meter within the operating
temperature range for 10 minutes or
more and retest.
Check the accuracy of your blood
glucose test strip by performing a
glucose control solution test. If the test
results in a normal reading, re-test your
blood sample two or three times.
If "Lo" persists, consult your doctor
immediately.
Check the accuracy of your blood glucose
test strip by performing a glucose control
solution test. If the test results in a normal
reading, re-test your blood sample two or
three times.
If "Hi" persists, consult your doctor
immediately.