Gluceofine Blutzucker-Mess-System Benutzerhandbuch Seite 58

Setting Your Blood Glucose Test Meter
Number of days for average
After pressing and releasing either
or buttons to set the number of
days for average calculation (3
di erent possible), con rm with
Alarm time
After pressing and releasing either
or buttons to set the alarm hour
and minute, con rm with
CAUTION
1. VERY IMPORTANT: Correct test unit.
Your Gluceo ne® blood glucose test meter is pre-set to mg/dL or to mmol/L as test unit. A
wrong test unit will lead to wrong test result display! Please consult your healthcare professio-
nal if you're not sure which test unit to use. Stored test results are displayed correctly after
re-setting the test unit. See also conversion table on page 85.
2. Without setting the date properly, the average glucose level and the results in memory will
not show proper values. It is recommended to set the blood glucose test meter before use and
when new batteries are installed.
3. Yon can't test your blood glucose in the setting mode.
4. To turn the meter o during the setup, press
58
Alarm on/o
After pressing and releasing
either
alarm on/o , con rm with
.
Alarm
After programming the number of
desired alarms (5 alarms possible),
con rm with
.
for at least 3 seconds.
or buttons to turn the
.
.