CODELOCKS CL5000 DND Kurzanleitung Seite 3

At the end of a sequence, the keypad will
flash twice
programming has been successful.
When in Programming Mode, a Program Code
must be entered within 5 seconds, otherwise
the Red LED will flash and beep and the lock
will revert to normal. If a programming mistake
is made, wait 5 seconds, the Red LED will flash
and beep and the lock will revert to normal.
Do Not Disturb Programs
Enable Do Not Disturb (Pre-set in the lock)
#(Sub)Master Code
Example: #12345678
Result: Do Not Disturb has been enabled.
Pressing the lock button on the Accessory
Panel will activate Do Not Disturb.
Pressing the unlock button will deactivate
Do Not Disturb. When activated, only Master
and Sub-Master Users will be permitted access.
Disable Do Not Disturb
#(Sub)Master Code
Example: #12345678
Result: Do Not Disturb has been disabled.
Note: Unplug the ribbon cable from the
Accessory Panel.
Basic Programs
Change the Master Code
Note: The Master Code is 8 digits in length.
#Master Code
New Master Code
Example: #12345678
87654321
Result: The Master Code has been changed
to 87654321.
Set or Change the Sub-Master Code
Note: The Sub-Master Code is 8 digits in
length. #Master Code
Code• New Sub-Master Code
Example: #12345678
445566677
Result: The Sub-Master Code has been
changed to 44556677.
•• confirming it's complete and
• 10 •
• •
• •
• •
• 18 • 1 • •
• 18 • 1
• 18 • 0 • •
• 18 • 0
New Master Code
• 10 • 87654321
• 13 • New Sub-Master
• 13 • 44556677
• •
• •
•
• •
•
•