Cautions; Warning - Autool Hts705 Benutzerhandbuch

CAUTIONS

Warning

Before using the instrument, please read this manual careful-
ly for proper operation.
If cleaning moving objects, firstly be sure to turn off the drive
power of the objects to be cleaned.
The temperature of dry ice is -78.5 degrees, and gloves must
be worn for long-term contact with dry ice to prevent burns.
The object to be cleaned and sprayed contains a lot of dust, so
be sure to wear a protective mask.
The spray head shall not against people, and the dry ice
particles sprayed will hurt people.
Cleaning with dry ice will produce certain noise, and it is
necessary to wear noise-proof earmuffs during operation.
It is forbidden to touch dry ice and the barrel of ice spraying gun.
When adding dry ice, it must be kept clean and no other foreign
objects fall into the equipment.
This equipment uses solid CO2 particles, and ventilation must
be ensured when operating dry ice cleaning.
Before working, it is necessary to check whether goggles,
earmuffs, work clothes and gloves are worn.
Before each operation, first set the ice feeding speed to "0"
and test whether there is condensed water sprayed from the
nozzle.
When the operation is not finished and suspended, please
adjust the ice feeding speed to "0" , and then start the spray
gun to spray for 30-50s to ensure that the residual ice in the
feeding pipe is discharged and prevent ice blocking.
To ensure that the compressed air pressure flow of the air
source is sufficient, please choose the air source supply pipe
with an outer diameter greater than DN20 and an air source
pressure greater than 6bar, so as to achieve better cleaning
effect.
To prevent electric shock, please do not touch the working
equipment in the wet place or operate the equipment in the rain.
In case of equipment failure during operation, the power supply
shall be disconnected immediately.
6