Operations Instruction; Equipment Debugging; Adjusting The Volume Of Dry Ice Blasting; Final Work - Autool Hts705 Benutzerhandbuch

OPERATIONS INSTRUCTION

Equipment
debugging
Adjusting
the volume
of dry ice
blasting

Final work

● Connect the host to the external air source and external power
supply. Check whether the data of the air pressure indicator is
normal and whether the power connection is normal (make
sure the power supply is grounded normally).
● Make preparations for testing machine, including connecting
the machine and accessories properly, checking whether the
parts are loose, and cleaning the unnecessary items placed on
the machine body or the work area.
●
Turn on the power switch, then turn it to start mode first. And
then press the start switch on the handle to run, adjust the dry
ice volume from 0 to its maximum, check whether there is any
abnormality, and then put dry ice materials into the machine for
trial operation.
●
Add an appropriate volume of dry ice and cover the lid.
●
According to the required cleaning degree, turn the dry ice
volume adjusting controller to achieve the best effect as
needed (it is recommended to set it to "5" first and adjust it
according to the cleaning effect).
●
If the barrel with smaller inner diameter is adopted, it is recom-
mended to set it to "3" and then increase it as appropriate.
●
After confirmation, align the spray gun with the parts to be
cleaned, and press the start switch on the handle to enter the
cleaning procedure.
●
Turn the dry ice volume adjusting controller to "0" and start the
spray gun to spray for 30-50s until no water is sprayed.
●
The dry ice residue can be removed by extending the product's
spraying time, and manual cleaning is required if necessary.
● Turn off the power switch, disconnect the air source, and store
the spray gun and accessories.
11