Herunterladen Diese Seite drucken

Aqua Forte Vario1.1 Gebrauchs- Und Installationsanleitung Seite 12

Vorschau ausblenden Andere Handbücher für Vario1.1:

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

9. TROUBLE SHOOTING
Problem
Pump Does Not Start
Pump Won't Prime
Low Water Flow
Pump being noisy
10.
ERROR CODE
Item
Code
Description
1
E001
Abnormal input voltage
2
E002
Output over current
3
E101
Heat sink over heat
4
E102
Heat sink sensor error
5
E103
Master driver board error
6
E201
Circuit board error
7
E202
Master board EEPROM reading failure
8
E203
RTC time reading error
9
E204
Display board EEPROM reading failure
10
E205
Communication error
11
AL01
Auto speed reduction against high temperature
Note:
1. AL01 is not an error indication: when it appears the inverter will automatically switch to a
lower speed to self protect against high internal temperature. When the temperature drops
back to 68℃ the inverter will resume at the preset speed.
2. When causes for E002/E101/E103 lifts, the device will resume working automatically,
All manuals and user guides at all-guides.com
Corrective solution
•Power Supply fault, disconnected or defective wiring
• Fuses blown or thermal overload open
• Check the rotation of the motor shaft for free movement and lack
of obstruction.
• Motor windings burned out.
•Empty pump/strainer housing. Make sure the pump/strainer
housing is filled with water and the cover o ring is clean.
•Loose connections on the suction side.
•Strainer basket or skimmer basket loaded with debris.
•Suction side clogged.
•Pump is not primed
•Air entering suction piping
•Basket full of debris
•Inadequate water level in pool
•Air leak in suction piping, cavitations caused by restricted or
undersized suction line or leak at any joint, low water level in
pool, and unrestricted discharge return lines.
• Disassemble pump, clean impeller, follow pump service
instructions for reassembly.
•Vibration due to improper mounting, etc.
10
Analysis
Not faulty
Not faulty
Contact your supplier
Contact your supplier
Contact your supplier
Contact your supplier
Contact your supplier
Contact your supplier
Contact your supplier
Contact your supplier
Contact your supplier

Werbung

loading

Diese Anleitung auch für:

Vario1.5Vario2.2