Bestway Swimfinity Bedienerhandbuch Seite 4

2. Press and hold this button in any state to enter the distance mode setting interface, and the m/yd indicator will flash. Press the
"+/-" button to set the parameter increase or decrease (range 10-5000 m/10-5500 yards). After the setting is completed, press
the start button to start the operation. (Pressing this button without holding it down will switch between m/yd units)
E Stop button
1. In all cases except the standby state, press the stop button to clear the current data and the machine will enter the standby state.
2. When the fault code is reported, press this button to cancel the fault and the machine enters the standby state.
F Speed and parameters adjustment buttons
During operation, you can accelerate or decelerate by pressing the "+/-" key; in the mode setting, you can set the parameter to
increase or decrease by pressing the "+/-" key.
G Start/pause button
1. Press this button in the standby mode to enter the free mode, and press this button to pause during operation. The machine will
stop automatically after a maximum of 90 minutes of operation.
2. After the calorie consumption, timing or distance mode setting is completed, press this button to start running. Press this button to
pause during operation.
H LED light switch button
Press to turn on/off the LED light
I Distance unit indicator
m/yd indicator
J Speed Setting Display
One speed bar represents one speed setting, which is represented from left to right with green representing slower speeds and red
representing faster speeds. The default speed when the machine is activated is set at 4 speed bars.
Remote control:
A Indicator light
Flashes a red color when a button is pressed
B Speed Adjustment Buttons
Press to increase or decrease the speed setting
C Emergency stop button
In an emergency, press the emergency stop switch to completely cut off the power to
the device.
D Start/pause button
Press to start or pause
If the remote control or the body of the Swimfinity is replaced,they must be paired again using the following instructions:
1. Ensure the body of the Swimfinity is in standby mode.
2. The remote control must be within 3 m (10 ft.) from the control panel.
3. On the remote control, press the speed adjustment buttons
Hold it until you hear the buzzer sound. This means the pairing was successful.
Important: after the paring operation is finished, the
button on the control panel to reset the alarm, and you may use your Swimfinity.
MAINTENANCE
Please disassemble and store the product indoors when the device will not be used for a
long period of time.
1. Turn off the transformer and unplug the power cable from the electrical outlet.
2. Disconnect the machine power cable from the transformer.
3. Remove the machine from the pool , and air-dry thoroughly .
4. Store the machine and transformer in a dry place. The storage's temperature should be
between 4°C and 40°C.
and emergency stop button
alarm will appear on the control panel. This is normal. Press the stop
4
A
B
at the same time.
D
C