Raddy RF760 Bedienungsanleitung Seite 14

RADDY RF760 Full-Band Radio
10.
storage address number will flash all the time. The frequency point will
always change incrementally in the process.
Note: When stations are searched, press [BAND] or any other key to
stop searching station.
During automatic station search and storage, previous frequency
points memorized will be updated.
9.3 Time state: short press the alarm clock to open/close the time
state (specific operations are described in 8.2 Operation
Introduction)
Operations for Step/Delete [STEP] :
10.1 In the power-on state, press [STEP] to set the STEP value
The following step options are available in all frequencies
@ FM stepping: 50.0 KHz, 10.0 KHz, 100.0 KHz.
(MW frequency: 522-1710 KHz, stepping: 9.0 KHz, 3.0 KHz.
(European)
MW frequency: 520-1710 KHz, stepping: 10.0 KHz, 5.0 KHz. (US)
@ SW stepping: 5.0 KHz, 1.00 KHZ, 0.10 KHz, 0.02 KHz, 0.01 KHz.
@) AIR stepping: 25.0 KHz, 12.5 KHz, 8.3 KHz.
© CB stepping: 5.00 KHz, 1.00 KHz, 0.10 KHz, 0.02 KHz, 0.01 KHz.
@© VHF/UHF & UBD stepping: 25.0 KHz, 12.5 KHz, 7.5 KHz, 5.0 KHz,
1.0 KHz.
Once the step value is selected, the system will default to the last
selected step value. Press [TUN ",0"] to confirm the last selected
step value.
10.2 Delete the radio
In startup state, after manual station storage is done according to 7.1
or automatic station search and storage operation according to 9.1.
Tap [Memo] and "Pxxx"will flash; short press [TUN"? , 0 "Jto select
the station to be deleted; then, long press [STEP] for two seconds
and it shows that "DEL & Exxx" flashes. Then, short press [MEMO]
to delete the station and exit "DEL & Exxx".
—12—