GBC Ultima 65 Bedienungsanleitung Seite 8

Lamination Speed Guide
When using AutoSpeed the machine will operate at speed setting 4
and adjust the speed of the laminator automatically based on roller
temperature changes to ensure quality output.
Turn-off AutoSpeed by pressing the Speed Control dial and manually
set the speed based on the recommendations below.
Media Type
Thin (News Print)
Medium (Copy Paper)
Thick (Card Stock)
Heavy Stock (Poster Board)
Guarantee
Operation of this machine is guaranteed for 1 year from date of
purchase, subject to normal use. Within the guarantee period, ACCO
Brands Europe will at its own discretion either repair or replace the
defective machine free of charge. Defects due to misuse or use for
inappropriate purposes are not covered under the guarantee. Proof
of date of purchase will be required. Repairs or alterations made
by persons not authorised by ACCO Brands Europe will invalidate
the guarantee. It is our aim to ensure that our products perform to
the specifications stated. This guarantee does not affect the legal
rights which consumers have under applicable national legislation
governing the sale of goods.
Register this product online at www.accobrands.com
8
• Do not attempt to laminate abrasive or metal items such as staples
• Do not force items into the nip area of the rollers. An item that is not
• Wrinkles may result if an attempt is made to reposition an item
Speed
• Do not stop the laminator before an item has completely exited the
4 - 6
3 - 5
• Adhesive will be deposited on the Heat Rollers if:
2 - 4
1 - 2
If you experience a technical fault with your product during the
warranty period, please contact the relevant ACCO service centre.
Depending on the diagnostics and the model type, we will either
arrange a service call by an engineer or we will ask you to return
the machine to ACCO. If you return the machine, ACCO will, at its
discretion, in accordance with law, either (i) repair the machine using
either new or refurbished parts, or (ii) replace the machine with a
new or refurbished machine that is equivalent to the machine being
replaced.
Lamination Tips
or paper clips as they will damage the heat rollers.
easily drawn into the laminator is probably too thick to laminate.
once the rollers have grasped it.
rear of the laminator. Even a momentary stop will cause a mark
(heat line) to appear on the laminated item.
- only one roll of film is used. The top and bottom rolls must be
used for problem free lamination.
- one or both rolls of film are allowed to run completely off the
core.
- top and bottom roll film edges are not evenly aligned.