WYBOT C1 Pro Benutzerhandbuch Seite 6

iOS 15.0 or later
Choose your cleaning mode
You can preset a suitable cleaning mode for your device on the device through press-
ing the on/off button. You can also select one cleaning mode via the app.
There are 3 cleaning modes on the device, and you can see details below.
Mode
Full pool cleaning
Floor cleaning
Wall cleaning
Note:
1. You can preset your cleaning mode before putting the device into the pool.
The default mode is full pool cleaning.
2. If the device restarts, it will automatically enter the cleaning mode you set last
time
Preset your cleaning cycle via the app
You can start to schedule your cleaning cycle through clicking the "cycle timer" on
the app, and select the one you prefer. You may refer to below for a better under-
standing of the working principle.
05
iOS Android
Android 8.0 or later
Cleaning Range
Wall+ Floor+Waterline/Wall then floor
*You can define a specific mode from the app
Floor only/Turbo floor/ECO floor
*You can define a specific mode from the app
Wall only
eg WYBOT C1 Pro(OS7010) cycle timer
1st day
Cycle 1 120min*1
120min.
(default)
1st day
24 hours
60min.
Cycle 2 60min*2
1st day
24 hours
Cycle 3 40min*3
40min.
1st day
48 hours
Cycle 4 30min*4
30min.
Note:
1. If you have selected a cycle cleaning mode,
charged before.
2. The default cleaning cycle of WYBOT C1 Pro(OS7010) is one time cleaning for 2
hours, and WYBOT C1 Max(OS7010 Max) is one time cleaning for 3 hours.
3. If your select other cleaning cycles,
complete whole cycles.
Run your new WYBOT C1 Pro/Max(OS7010/OS7010 Max)
Hold the handle of the cleaner and submerge it into the pool within 3 minutes, other-
wise the device will be turned off. Additionally, you should not release it until no bubble
comes out.
2nd day
60min.
2nd day 3rd day
24 hours
40min.
40min.
3rd day
5th day
48 hours
48 hours
30min.
30min.
you should ensure the cleaner is fully
you should keep the cleaner in the pool to
7th day
30min.
06