Metz mecablitz 64 AF-1 digital Bedienungsanleitung Seite 975

3.3 Switching the flash unit on and off
• Switch on the flash unit with the
The start screen appears.
The flash unit always switches on after-
wards with the mode of operation that was
used last (e.g. manual flash mode M).
MB 64AF-1
The
digital
mode. To switch off the flash unit, press
OLY
the
V 1.0
If the flash unit will not be used for an exten-
ded period of time, we recommend that you
switch off the flash unit with the
ton and remove the power source (disposa-
ble/rechargeable batteries).
3.4 The selection menu
• Press the
for the selection menu to appear.
k
The selection menu is divided into 6 sensor
MODE
buttons:
MODE
The modes of operation can be set after
pressing the
TTL
TTL, chap. 7.1
TTL FP
TTL FP*, chap. 7.4
A, chap. 7.5
A
M, chap. 7.3
M
M FP*, chap. 7.4
M FP
STROBO, chap. 7.6
STROBO
REMOTE SLAVE, chap. 10.2
SERVO, chap. 10.4
REMOTE SLAVE
*) only after data exchange with a camera
SERVO
152
All manuals and user guides at all-guides.com
button.
button flashes red in stand-by
button until all displays turn off.
but-
button as often as it takes
MODE
button.
The flash parameters can be set after
PARAMETER
pressing the
P (partial light output),
PARAMETER
chap. 7.3 and 10.4.3
EV (exposure correction), chap. 8
P / EV
ZOOM (reflector setting), chap. 9.1
ZOOM
N (Strobe number of flashes), chap. 7.6
N
f (Strobe flash frequency), chap. 7.6
f (Hz)
F (aperture)
ISO (light sensitivity),
F
CHANNEL (Channel), chap. 10.2.2
ISO
GROUP (slave group), chap. 10.2.3.
CHANNEL
The displayed flash parameters are depen-
GROUP
3)
dent on the selected flash mode.
The touch display can be configured after
pressing the
SERVICE
can be reset to the factory setting.
SERVICE
BRIGHTNESS , chap. 15.1
ROTATION (rotate the screen display),
BRIGHTNESS
chap. 15.2
RESET, chap. 16.3
ROTATION
RESET
PARAMETER
button.
SERVICE
button, or the flash unit