Silvercrest 459227 2401 Bedienungsanleitung Seite 32

Keep a minimum distance of 100 cm
from other objects around the device.
Never operate the device in a potential-
ly explosive environment or close to
flammable gases or liquids.
Ensure at all times that the air can enter
and exit freely. Heat can otherwise ac-
cumulate in the device.
DANGER! Risk of injury
through burning!
The device remains very hot after it is
switched off, and must not be touched.
Prior to cleaning, let the device cool
down until there is no longer a risk of
burning.
WARNING! Risk of material
damage!
Never operate the device in the vicinity
of other heat sources or naked flames.
Only use the original accessories.
Do not clean using sharp objects or
abrasive cleaning agents.
4. Items supplied
1 wall-mounted fan heater 1
1 remote control 8 with CR2025 (3 V) bat-
tery inserted
2 screw 25 mm 18
2 rawlplug 19
1 drilling template 21
1 copy of the short manual (included)
1 copy of the operating instructions (online)
Unpacking
1. Remove all parts from the packaging.
2. Check that all parts are present and in-
tact.
30 GB
5. How to use
5.1 Remote control
The remote control 8 is supplied with a
CR2025 (3V) battery inserted.
• Before switching on, remove the plastic
strip from the remote control.
Changing the battery in the
remote control
DANGER!
There is a danger of explosion if the bat-
tery is not correctly replaced. Replace
only with the same or an equivalent
type.
1. Press the small lever
2. Replace the old bat-
3. Slide the battery compartment 13 into
the remote control 8.
on the side of the bat-
tery compart-
ment 13 gently in the
direction of the mid-
dle, and then pull the
battery compartment
out of the remote con-
trol 8 in the direction
of the arrow.
tery with a new one.
The positive pole (+)
of the battery must be
pointing upwards.