Forced Start Mode - Autool Em365 Bedienungsanleitung

Forced start
mode
Voltage (V)
13.4
Current (A)
3.1
Vehicle Display Mode: Set the charging voltage within the
●
range of 10.8V to 16.0V. In standby mode, a small current float
charge is applied to the battery. When detecting battery
discharge, a maximum current of 40A can be output to main-
tain the battery in a fully charged state. If the set voltage is
lower than the battery voltage, the system will automatically
set the charging voltage to: battery voltage + 2V.
Battery Charging
Voltage (V)
14.0V
● Connect the power clamps to the vehicle's positive and nega-
tive terminals.
Select "Start," and the interface will display "Please start the
●
vehicle." When the current exceeds 50A, the interface will
automatically switch to display the starting voltage and current.
●
After starting the vehicle, if the current exceeds 150A for 1
second, protection will be triggered. If the current exceeds
400A for 500 milliseconds, protection will be triggered.During
the protection period, output will be interrupted. Press the "OK"
key to resume operation.
Time (S)
236
Temperature (°C)
30
Battery Restoration
Vehicle Display Mode
22
Restoration Completed
Please confirm that the
battery voltage is within
the compatible range.
(10.8~16V)
Voltage (V)
13.4
Current (A)
3.1
Progress (%) Charging
15