Electrical Connection; Internal Light - AEG Electrolux FAVORIT 88040VI Benutzerinformation

48
Safety information
– Be careful when you connect the water inlet hose:
– Do not put the water inlet hose or the safety valve in water.
– If the water inlet hose or the safety valve are damaged, immediately disconnect
the mains plug from the mains socket.
– Contact the service centre to replace the water inlet hose with safety valve.
WARNING!
Dangerous voltage.

Electrical connection

• The appliance must be earthed.
• Make sure that the electrical data on the rating plate agree with your domestic power
supply.
• Always use a correctly installed shockproof socket.
• Do not use multi-way plugs, connectors and extension cables. There is a risk of fire.
• Do not replace or change the mains cable. Contact the service centre.
• Make sure not to squash or cause damage to the mains plug and cable behind the
appliance.
• Make sure that the mains plug is accessible after the installation.
• Do not pull the mains cable to disconnect the appliance. Always pull the mains plug.

Internal light

This appliance has an internal light that comes on when you open the door and goes off
when the door is closed.
WARNING!
Visible led radiation, do not look directly into the beam.
The LED lamp is CLASS 2 in accordance with IEC 60825-1: 1993 + A1:1997 + A2:2001.
Emission wave length: 450 nm
Maximum emitted power: 548 μW
To replace the internal light, contact the service centre.
Disconnect the mains plug from the mains socket before the replacement of the internal
light.