i.safe MOBILE IS-RSM3A.1 Bedienungsanleitung Seite 5

Do not expose the device and the IS-DCRSM3.1 Desktop Charger to strong UV radiation.
Do not expose the device and the IS-DCRSM3.1 Desktop Charger to processes with high
electrical charges.
Do not expose the device and the IS-DCRSM3.1 Desktop Charger to aggressive acids or
bases.
Protect the device and the IS-DCRSM3.1 Desktop Charger from strong electrical magnetic
fields as for example those emitted by induction cookers or microwave ovens, for example.
Only use accessories approved by i.safe MOBILE GmbH.
Do not open the device and the IS-DCRSM3.1 Desktop Charger or carry out any repairs
yourself.
Do not use the device and the IS-DCRSM3.1 Desktop Charger in places where its use is
prohibited.
Turn off the device in clinics or other medical facilities.
Always keep a safety distance of at least 15 cm between the device and a pacemaker or
hearing aid. The device can affect the functioning of medical devices such as pacemakers and
hearing aids.
When using the device while driving a motor vehicle, be sure to comply with applicable
national laws.
When using headsets at the maximum volume setting, first set the volume control on the
device to 50 % of the maximum volume.
Do not charge the device in the vicinity of flammable substances.
Only charge the device using the charging equipment approved by i.safe MOBILE GmbH.
Only charge the device at ambient temperatures between 0 °C to +45 °C (+32 °F to +113 °F).
Only charge the device under dry indoor conditions.
Do not charge the device in environments dusty or humid.
EX-RELEVANT SAFETY REGULATIONS
Use of this device assumes that the operator observes the conventional safety regulations and
has read and understood Operating Manual, Safety Instructions and certificate.
When used in explosion hazardous areas, the following Safety Instructions must also be
complied with:
CONNECTION
Only connect the IS-RSM3A.1 (wired version) outside explosion hazardous areas to the 16-pin
ISM interface.
The 16-pin ISM connector of the IS-RSM3A.1 (wired version) must be securely fastened to the
16-pin ISM interface.
ACCESSORIES
It is allowed to connect accessories approved by i.safe MOBILE GmbH inside explosion
hazardous areas to the 8-pin circular ISM interface.
The following accessories may be connected to the 8-pin circular ISM interface:
-the Headset IS-HS4A.1
-the Headsets IS-HDHS3x.1
When using accessories with Velcro fasteners (e.g. Headset IS-HDHS3B.1), the Velcro fastener
may only be adjusted outside explosion hazardous areas.
EN
5