i.safe MOBILE IS-RSM3A.1 Bedienungsanleitung Seite 4

ENGLISH
PROTECT YOUR LIFE AND READ THE
OPERATING MANUAL
This Operating Manual is part of the device IS-RSM3A.1 (model MRSM3AA01)/IS-RSM3B.1
(model MRSM3BA01). This Operating Manual provides important information for safe use of
the device.
Before using the device, read this Opertaing Manual carefully and pay particular attention
to the „ Ex-relevant Safety Regulations " section and the warnings highlighted with the war-
ning symbol. If you do not follow these instructions or do not understand them, this could
lead to death, severe injuries and damage to the device.
Make sure you have access to this Operating Manual when you need it. You can find the
current Operating Manual at www.isafe-mobile.com/en/support/downloads
Follow all instructions given on the device and on the packaging.
Follow local safety regulations.
Only use the device in explosion hazardous areas of zones 1/21 and 2/22 or outside of
explosion hazardous areas.
Before entering an explosion hazardous area with the device,
- make sure that the IS-RSM3A.1 is securely fastened to the 16-pin ISM interface, see section
"Connecting the device",
- make sure that only approved accessories are connected to the device, see section
"Connecting approved accessories",
- make sure that no gap can be seen between the two halves of the device,
- make sure the device is not damaged,
- make sure that all the labels on the device are readable,
- make sure that only the battery supplied or an approved replacement battery
is installed in the device,
- make sure that the battery is not damaged,
see section „Changing the battery",
- make sure the battery is screwed tight.
If you use the device in an explosion hazardous area,
- do not loosen the screws on the device,
- do not disconnect the 16-pin ISM connector of the IS-RSM3A.1 from the
16-pin ISM interface,
- do not charge the device,
- do not open the device,
- do not damage the device.
Switch off the device immediately and leave the explosion hazardous area without delay if
- malfunctions occur on the device,
- you have damaged the housing of the device,
- you have exposed the device to excessive loads,
- the device has been stored improperly,
- the labels on the device are no longer readable.
Do not modify the device and the IS-DCRSM3.1 Desktop Charger structurally.
Do not expose the device and the IS-DCRSM3.1 Desktop Charger to high temperatures.
4