Tognana IRIDEA D2DMLD2IR Benutzerhandbuch Seite 19

function LED (green) will blink. After 2 seconds, the "heat" LED remains steadily lit and the appliance
starts working. At the end of processing, the appliance emits an acoustic signal and the "heat" LED
turns off; the appliance stops working and goes back into standby mode. The milk temperature is now
60±5°C.
f) COLD FROTH: in standby mode, press the ON button three times, the three function LEDs will turn
on and the "cold froth" function LED (blue) will blink. After 2 seconds, the "cold froth" LED remains
steadily lit and the appliance starts working. At the end of processing, the appliance emits an acoustic
signal and the "cold froth" LED turns off; the appliance stops working and goes back into standby
mode. The frothed milk and its temperature are the same as at the start.
7. To cancel the selected function when the milk frother has already started, press the ON button; the LED
of the selected function will turn off and the milk frother goes back into standby mode. If necessary,
reselect a function and press the ON button again.
8. Disconnect the plug from the power socket, lift the carafe and pour the contents into a suitable container.
HAZARD:
• Pour the hot milk slowly and take care not to move the milk
frother too suddenly to avoid the risk of splashes.
• Always disconnect the power when the appliance is not being
used.
RECOMMENDATIONS FOR USE
1. For best frothing results it is recommended to use whole milk (fat content >3%).
2. The milk can be heated up to a maximum of 60°C (±5°C). This is the ideal temperature that will not
damage the molecular structure and nutritional content of the milk and can increase the flavour and
taste without waiting too long.
3. After use, wait at least 2 minutes before using the appliance again, thus allowing the electrical and
electronic components to properly cool and avoiding the risk of overheating.
4. To pour the froth, use suitable wooden or plastic utensils so as not to scratch the non-stick walls of the
carafe
5. Cleaning the appliance will be easier if done immediately after use.
OVERHEATING PROTECTION AND "NO-LOAD" POWER-ON
If the milk frother is accidentally left on without any milk, causing it to overheat, the safety protection is
automatically activated; an acoustic signal is emitted and the appliance will automatically turn off. In this
case, leave the milk frother to cool before using it again (about 15 minutes).
CLEANING AND MAINTENANCE
Before cleaning, always disconnect the milk frother from the power socket and leave it to completely cool.
Cleaning the appliance will be easier if done immediately after use.
1. Removing the milk residue
Insert the hot froth accessory. Fill the carafe with water up to the maximum level indicated inside the carafe
and close it with the lid.
Push the ON button 2 times and the appliance will start to work, heating and mixing the water to remove
the milk residue from the carafe.
2. Clean the outside of the carafe
Clean the outside of the carafe with a soft cloth or slightly dampened sponge and dry with a cloth.
19