Numark M6 USB Kurzanleitung Seite 4

Numark
REAR PANEL FEATURES
Nunurl« M6USB
POWER IN — Use the included power adapter to connect the mixer to a power outlet.
is switched off, plug the power supply
outlet.
2 VOLTAGE SELECTOR —This 2-position switch sets the AC input voltage for the speaker.
should set this switch to "100-120V"
'220-240V"
POWER SWITCH —Turns the mixer on and off. Turn on the mixer after all input devices have been
3
connected and before you turn on amplifiers. Turn off amplifiers before you turn off the mixer.
4 GROUNDING TERMINAL
grounding wire to these terminals. If you experience a low "hum" or "buzz", this could mean that your
turntables are not grounded
Note: Some turntables have a grounding wire built into the RCA connection and, therefore, nothing
needs to be connected to the grounding terminal.
PHONO INPUTS (RCA) —Connect phono-level
5
6 LINE INPUTS (RCA) — Connect
to these inputs
CH3 USB —Outputs the Record mix to your computer for recording purposes or sends incoming audio
7
from your computer to mixer's Channel 3
MIC 2 INPUT —If you would like to use an additional 1/4" microphone on Channel 4, connect it to this
8
input. To route the microphone
switch, located on the top panel, to "Mic"
MASTER OUTPUT (BALANCED
9
amplifier system. The level of this output is controlled with the MASTER FADER on the top panel.
10 MASTER OUTPUT (RCA) — Use standard RCA cables to connect this output to a speaker or amplifier
system. The level of this output is controlled by the MASTER FADER on the top panel.
BOOTH OUTPUT (RCA) — Use standard RCA cables to connect this output to a booth monitoring
11
system. The level of this output is controlled by the Booth knob on the top panel.
12 RECORD OUTPUT (RCA) - Use standard RCA cables to connect this output to a recording device,
such as a CD recorder or tape deck. The level of this output is based upon pre-master
OUTPUTS
CH3 USB
nan
VASTER
o o @Eooooooo
BALANCED OUTPUT
into the mixer first, then plug the power supply
whereas U.K. and most European
— If using phono-level turntables
devices, such as turntables, to these inputs
line-level devices, such as CD players, samplers or audio interfaces,
signal to the mix, you will need to flip the Channel
XLR) — Connect this low impedance
4
CHA CH3 CH2 CHI
öönnnö
While the power
into a power
U.S. users
users will need to set this to
with a grounding wire, connect
4 Input Selector
XLR output to a speaker
levels.
the
or