Yedoo OOPS Bedienungsanleitung Seite 6

5.b
Check that the pads make enough
space (1–2 mm) after releasing the brake
levers. The distance can be adjusted by
tightening or loosening the brake cable
at the anchor screw (2).
6.
Protective pad installation
(OneToo, Too Too I Special Edition)
Place the soft protective pad from
washable nylon over the handlebar
stem.
7
5.c
2
3
In case the brake pad is touching
the wheel when turning, symmetrically
adjust the distance of brake arms by
the tightening screws (3).
6.a
1
Protective pad installation
(YooToo, TooToo)
Turn the neoprene cover bottom side
up, slip it below the handlebar (1) and
fasten the press stud around the neck of
the stem (2).
Turn the cover over the handlebar (3).
3
3
2
5.d
Fasten the end of the brake cable in
the lock and secure with the cable tie,
then trim the tie.
6.b
Turn the side slip around the column
of the stem and fasten the press stud.
EN