Trust MATTER & START-LINE SMART MACM-250 Bedienungsanleitung Seite 12

EN
MACM-250 MATTER & START-LINE SMART BUILT-IN DIMMER
10. PAIRING WITH START-LINE TRANSMITTER
Press the "FUNCTION" button shortly to activate pairing mode. Pairing mode will be active for 12 seconds
A
and the LED indicator on the built-in switch will flash green.
During pairing mode (within 12 seconds), send an ON signal with a Trust Switch-in Start-Line transmitter.
B
The connected lighting will go ON-OFF-ON-OFF to confirm that the transmitter has been paired.
C
The built-in dimmer can store up to 32 different transmitters in its memory.
11. WIRELESS CONTROL WITH START-LINE TRANSMITTER
Send an ON signal with the paired Start-Line transmitter to switch on the light/device wirelessly.
Send an OFF signal with the paired Start-Line transmitter to switch off the light/device wirelessly.
12. ACTIVATE DIMMING SEQUENCE
- Press the ON button of a paired transmitter to switch on the dimmer.
- Press ON again to activate the dimming sequence
- Press ON a third time to lock the desired dimming level
The dimming sequence automatically stops and locks the dimming level at the highest or lowest point when no
signal is given with a transmitter.
ACTIVATE DIMMING SEQUENCE WITH 230V WALL SWITCH
To activate the dimming sequence with a 230V wall switch, first switch it ON.
Then quickly switch the wall switch OFF and ON. To fix the dimming level, quickly switch the wall switch OFF and ON
again.
13. DIMMING MODE
If your lighting vibrates, you can choose a different dimming mode.
Turn off the dimmer with the Matter App or Start-Line transmitter.
Press the "FUNCTION" button on the dimmer for 3 sec until the LED flashes yellow and then release.
A
For leading edge mode, the LED flashes yellow once: This mode is most suitable for dimmable incandescent,
B
halogen, lamps with a traditional (wound) dimmable transformer and specific LED lamps
12