Trust MATTER & START-LINE SMART MACM-250 Bedienungsanleitung Seite 11

6B. INSTALLATION DIAGRAM SINGLE WALL SWITCH
This is the technical installation diagram of the built-in dimmer with a wall switch.
7. CONNECTION BEHIND WALL SWITCH (NOT SUITABLE FOR HOTEL SWITCHING)
• Note how the existing wires are connected and disconnect the wall switch.
• Connect the switch wire (black) from the wall box to the [
• Connect the live wire (brown) to a terminal block.
• Connect a new live wire (brown) from the terminal block to the L contact.
• Connect a new live wire (brown) from the terminal block to the wall switch (where the live wire (brown)
was previously placed)
• Connect a (blue) neutral wire to the right [N] contact. If there is no neutral wire, it must be pulled.
Consult an electrician if in doubt.
• Connect a new black switch wire to the S contact and connect it to the wall switch (where the black
switch wire was previously placed)
8. TURN ON THE MAINS POWER
Turn on the mains power before continuing with the installation.
stripped parts of the wires are touched.
To connect the built-in switch to a Matter App, proceed to step 9.
To connect the built-in switch to a Trust Switch-in Start-Line transmitter, proceed to step 10.
9. CONNECT TO MATTER APP
Make sure the phone or tablet is connected to a 2.4 Ghz WiFi network and not to a 5 Ghz WiFi network.
Open the Matter App (e.g. Apple Home or Google Home App) on your phone or tablet.
A
Short press the "FUNCTION" button to start Matter pairing mode. The LED indicator on the dimmer will
B
flash green. (Matter pairing mode lasts for 5 min, connect the dimmer to a Matter App within these 5 min)
Follow the instructions in the App to connect a new Matter device. If you are unable to connect the built-in
C
dimmer, reset it according to the step "Reset Matter Built-in Dimmer"
MACM-250 MATTER & START-LINE SMART BUILT-IN DIMMER
L L
] contact.
After this step, make sure that no
EN
11