Beatbot AquaSense 2 Ultra Bedienungsanleitung Seite 9

5 Robot Buttons
1
Power Button
3
Short press to turn the robot on, and press and hold for about 3s to turn it off.
Mode Button
Short press the corresponding mode button to switch.
Floor Mode ( ): Clean the floor;
1
(Press and hold for about 3s to enable the dispensing of clarifier.)
Standard Mode ( ): Clean in the order of floor, walls and waterline;
2
Pro Mode ( ): Clean in the order of floor, walls, waterline and surface;
4
Custom Mode ( ): You can set the cleaning area and duration according to your needs via
5
the App. Once your settings are successfully configured in the App, they will sync with this
mode button.
Hotspot Configuration
Press and hold both the "Power (
about 3s to trigger the hotspot configuration.
Factory Reset
Press and hold the "Standard Mode (
simultaneously for about 10s to restore the factory settings.
6 Lighting Effects
Solid green light
Solid yellow light
Solid orange light
Solid purple light
Flashing orange light
Flashing blue light
Breathing light
2 3
)" and "Floor Mode (
3
)", "Power (
2
7
4
)" buttons simultaneously for
1
)" and "Pro Mode (
3
Battery sufficiently charged
Battery low
Battery nearing depletion
Clarifier dispensing
Robot malfunction
Network configuring/OTA upgrading
Charging
5
5
)" buttons
4
EN