Herunterladen Inhalt Inhalt Diese Seite drucken

Lionelo Fidi Plus Bedienungsanleitung Seite 11

Muttermilchpumpe
Inhaltsverzeichnis
Verfügbare Sprachen

Verfügbare Sprachen

  • DEUTSCH, seite 22
or under warm running water with a maximum temperature of 37°C.
3.
Before feeding, shake the milk container gently to mix the milk evenly.
4.
Do not defrost frozen milk in the microwave or boiling water to avoid losing
nutritional value and burning your baby.
5.
Never re-freeze milk that has already been defrosted once and store it
either at room temperature or in the refrigerator.
Charging (fig. E)
1.
Connect the DC plug of the cable to the device's power socket on the side
of the main body, and connect the other end with the USB plug to the USB
adapter (not included).
2.
During charging, the battery level indicator flashes green. When it stops
flashing, it indicates that the device is fully charged.
3.
The device automatically detects the battery level. When the battery level
is high, the battery level indicator lights up green. When more than half of
the battery is used up, the battery level indicator lights up yellow. When
the battery level is low, the battery level indicator starts to glow red, and
when the indicator starts to blink, the device will turn itself off after a while.
NOTE
You can use the breast pump while the battery is charging, but extreme caution
is recommended. However, please note that frequent use of the device while it
is charging may result in reduced battery life.
Use a DC5V/1A adapter for charging.
Troubleshooting
Problem
The device does
not switch on
Insufficient suction
power
Solution
The device's battery may have discharged or entered a protective state
caused by long storage. Connect the device to the adapter to activate
the battery.
Fully charge the battery before using the device for the first time and
after long-term storage.
Check that the silicone funnel of the device fits snugly to the breast.
Check whether all parts of the device are correctly and fully installed.
If the room temperature is below 15°C, leave the device running for
about 30 seconds before using it.
‑ 11 ‑
EN
Inhaltsverzeichnis
loading

Inhaltsverzeichnis