Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• Notes:
OPIease check if there is a rubbish at the mouth of dustbin and then clean it after the dust box is
took
out.
(2)Thefilters can be washed and then placed in a ventilated dry shade for air drying and reuse.
CLEANING
OF
SENSOR
AND
CHARGING
Clean the infrared induction window of the front bumper of main body and four anti- falling infrared
windows at the bottom of main body regularly
Clean charging
pole pieces at the bottom of main body and also charging pole pieces of
docking
station
THE CLEANING
OF MOP
Cleaning of the mop and water tank after the every cleaning. Please to do below steps:
• Taking the water tank from the bottom of main body , then to remove the mop
• Open the cover of the water tank, dump the remaining water
• Cleaning water tank and mop by water, then to dry the mop
O
O
Notes:
If you don't use the mop you have to remove the water tank / mop holder.
10
POLE PIECE
O
0
Ox
FAILURE
CHECKING
ALARM
PROMPT
If the machine broken down, the prompt tone (A) will appear to remind the failure every 10
seconds
S/N
PROMPT TONE
FAILURE
CAUSE
01
Failureof infrareddetectionsystem
02
Failure
of blower
motor
03
Low battery of main body
04
AAAA
Failure of left and right wheels
05
Other
failure
POSSIBLE
PROBLEMS
AND
SOLUTIONS
Check
if Sien/Emma
Check
if the dustbin,
Sien/Emma is not working
Check if Sien/Emma
Check if the dustbin is properly installed
Shut
Sien/Emma
Clean the dustbin
Check
and
The suction power is weak
Check
and
Check
and clean
Check
and
Check
and clean
Sien
makes
a lot of noise
Check
and
Sien/Emma will try to come loose by them selfs but
Sien
is stuck
somtimes it needs manual help
• If the debugging
methods in the above chart are useless, turn off the main body first and then turn it
on to check
whether
it is abnormal
or not.
• If the debugging
methods in the above chart and restart are not available, please contact the
Zoef
Robot
• When the voltage of battery is too low, the main body may suffer dysfunction
indicate the abnormity. At this time, it is necessary to charge the main body manually
• When the machine is not in use, the main body shall be turned off. If the battery is discharging,
main body will enter into the recovery mode and the charging
DEBUGGING
METHOD
Cleanthe detectionwindow of thefront bumperandthe bottom
Remove
the rubbish
at the inlet and outlet
of blower motor
Charge the main body
Remove rubbish of the driving wheel is stuck by
Contact
the customer
service
staff
is ON
motor
and filters
are clean
needs to be changed
off
clean
the filter
and
the
motor
clean
the side
brushes
the sensors
clean
the wheels
the filter and dustbin
clean
the side
brushes
and
the wheels.
and the prompt will
may last 12 hours.
the
11
Werbung
