Electrolux IG2085SN Benutzerinformation Seite 51

Activation of the ECO deactivates Extra
Freeze function.
The ECOMETER indicator shows the
appliance's current energy consumption.
Three fully lit bars indicate the most
energy-efficient setup.
3.4 Extra Freeze function
Extra Freeze function is used to pre-freeze
and fast freeze in sequence in the freezer
compartment. This function accelerates the
freezing of fresh food and protects foodstuffs
already stored from warming.
To freeze fresh food, activate the Extra
Freeze function at least 24 h before
placing the food to complete pre-freezing.
Press the Extra Freeze button to activate this
function.
The Extra Freeze indicator lights up. The
Extra Freeze function stops automatically
after a maximum of 52 h.
Press the Extra Freeze button to deactivate
the function before it automatically ends.
3.5 High temperature alarm
When the temperature in the freezer
compartment increases, the alarm indicator
flashes, the freezer temperature indicator
shows blinking H° and the sound is on.
To deactivate the alarm, press any button.
The alarm indicator and sound turn off. The
freezer temperature indicator shows H° for 5
sec before indicating the freezer temperature
again.
The alarm restarts 1 h after deactivation
until the normal conditions are restored.
If you do not press any button, the sound
switches off automatically after 1h.
3.6 Door open alarm
The door open alarm indicator turns on with
the sound if the freezer door is left open for
80 sec.
The alarm stops after closing the door. Press
any button to switch off the sound.
If you do not press any button, the sound
switches off automatically after 1 hour.
3.7 Setting mode
The Setting mode allows you to enable or
disable the ECOMETER indicator, the Rest
mode, the Sabbath mode, to reset the
appliance factory settings and to change the
temperature units from °C to °F.:
Activating the Setting mode
1. Press and hold the ECO button for
approx. 3 sec. The display alternately
shows blinking
2. Once the Setting mode is switched on,
the display alternately shows
Press and hold the ECO button for approx. 3
sec to deactivate the Setting mode.
The Setting mode deactivates if you do not
interact with the control panel for 60 sec.
Navigating the Setting mode
Tap the temperature button to change the
parameter.
Tap the Extra Freeze button to change the
parameter value.
Display
and .
and
Default parameters
ECOMETER indicator
Button sounds
Temperature units
Sabbath mode
Rest mode
Factory settings
ENGLISH 51
.