Screen Display; Terms And Definitions - Komet Engo Gebrauchsanleitung

6 EnGO - Product Introduction
With the motor handpiece turned off, hold down the setting button "P" and press main button to enter handpiece functions setting, press setting
button "P" until the required target setting has been reached, press adjusting button "+"/"-" to adjust, then press main button to confirm.

3.2 Screen display

3.3 Terms and definitions

CW
CCW
RECIP
ATR
Forward Angle
Reverse Angle
EAL
AP
Apical Action
Flash Bar Position
Auto Start
Auto Stop
Apical Slow Down
Operation Mode
Standby interface
a) Customized program sequence number 0 - 9, totally 10 programs in total.
b) Battery consumption
c) Set speed
d) Set torque
e) Operation mode
Working interface
a) Set speed
b) Set torque
c) Real time torque
d) Torque display scale
Canal measurement mode interface
a) Apical reference point flash bar
b) EAL: Electronic apex locator
Canal measurement mode interface
a) Canal length indicator bar
b) Indication number
Digital numbers 00-16 do not represent the actual length from the apical foramen.
They simply indicate the file progression towards the apex. Number "00" indicates that the file has
reached the apical foramen.
c) Apical foramen.
Interface for setting the apical reference point
a) Apical reference point flash bar
b) Apical foramen
c) Digital "02" meter reading, very near physiological apical foramen.
Clockwise rotation, forward rotation
Be applied to rotary file
Counter clockwise rotation, reverse rotation
Be applied to special file, inject calcium hydroxide and other solutions
Safety Glide Path Mode
Adaptive torque reverse
Up to setting torque, the motor will move with ATR mode;
when torque reduce to normal value, the motor will clockwise rotate.
Angle of clockwise rotation of the file.
Angle of counter clockwise rotation of the file.
Electronic apex locator
In the mode, the device will work like a stand-alone apex locator
Apical foramen.
The file action when file tip reaches the flash bar point.
Shows the point inside the canal where specified apical action is triggered.
The file rotation starts automatically when the file is inserted in the canal.
The file rotation stops automatically when the fileis taken out of the canal.
The file slows down automatically as it approaches the apex.
Activating in CW and CCW operation mode.
5 operation modes for canal shaping and measurement.
Such as CW, CCW, RECIP, ATR and EAL.