CODELOCKS CL2000 Kurzanleitung Seite 4

Settings
Additional lock settings are available: change
lock/unlocked indicator, set the User Code
length and enable or disable the keypad sound.
Factory Reset
The lock can be reset to its original factory
settings. You may need to do this if the Master
Code is no longer known. To reset the lock,
you must have access to the battery
compartment in the rear of the lock.
Remove a battery.
1
Press and hold the 1 button.
2
Replace the battery whilst continuing
3
to hold the 1 button.
After the Blue LED flashes twice,
4
release the 1 button.
Within 3 seconds, press the 1 button
5
three times.
The Blue LED will flash twice confirming that
6
the lock has reverted to the factory settings.
Troubleshooting
Incorrect Code
After three consecutive incorrect codes,
the lock will not accept further keypad input
for 10 seconds.
Programming Error
If a programming mistake is made wait 5
seconds, the Red LED will flash and beep
and the lock will revert to normal.
Battery Failure
If the batteries fail, the key override can be
used to open the door. Open the battery cover
on the rear of the lock. Replace with high
quality AA batteries and ensure that they are
orientated correctly.
The CL2000 range has been designed so that a
PP3 battery can be used to open the lock should
batteries fail. For detaield instructions refer to the
full instructions at codelockssupport.com
Please refer to local authority recommendations
for the disposal of old batteries.