Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Commissioning:
• Now connect the battery cable to the charger (Fig. 1). Plug the charger into
an AC socket (Fig. 2). If the power pack is not connected to the charger, turn the
power pack plug through 90 degrees and connect it to the charger (delivered in assembled state).
3
Battery
box:
Safety
instructions:
• Charge the battery completely prior to a quiet period or at least every 3 months.
• The battery should be disconnected from the compressor when not in use to avoid self-discharging.
This
extends
its service
• Store the battery in a dry and clean condition, ensuring that it is not directly exposed to sunlight or a
source of heat. The maximum
• Do not destroy or burn the battery, as it can explode or toxic substances
• Do not expose the battery to any extreme conditions
• The battery should no longer be used if you hear feint noises from it, notice severe temperatures
or a liquid emerges.
• DOnot touch or use the battery when it is hot.
• DO not remove the protective
• Should the battery run flat during use, switch Offthe unit to avoid excessive discharging.
• DO not pull on the battery cable if you wish to remove it from the unit.
• Allow the battery to cool prior to charging if it has been used before.
14
14
life.
storage temperature
outer sheath or cut into the battery jacket.
2
• If the LED light is red, the charger charges
the battery.
• If the LED light is green, the battery is fully
charged, then trickle charge will be started
(Fig. 3).
• If the LED light is flashing red, the voltage Of
the battery is too low.The battery will be
charged with small current first. When the
LED light is red again, the battery is charged
normally.
is 350 C.
such as cyclising or severe charging / discharging.
may leak out.
Werbung
