Control The Clinch; Adjust The Clinch; Adjust Staple Clinch - Josef Kihlberg JK20T779L22 Betriebsanleitung

Josef Kihlberg JK20T779L22

7.5 CONTROL THE CLINCH

1 Good clinch.
Correct
Correct
2 Leg length of the staple too long.
Correct
3 Leg length of staple too short.
Always use Josef Kihlberg original
To long staple
To long staple
staples: JK779-12 up to 22 mm.
To long staple
To short
To short
To short
Fel
Fel
Fel

7.6 ADJUST STAPLE CLINCH

Each plier is tested carefully before delivery. By rough
treatment during operation the anvil therefore might
need to be adjusted. Uncorrect clinching may then
occur (Fig. 9/1).
Correct
To long staple
– Insert a lose staple into the nozzle (Fig.10/1).
– Unscrew the three screws on the rear of the anvil
a 1/4 turn. Raise the anvil to the staple edges and
adjust it so that the staple hits the anvil hollows sym-
To short
metrically.
– Then tighten the screws.
– Make a test-stapling in a piece of carton. If the anvil
is correct adjusted the clinch should be like in
Fel
(Fig. 9/2).
10
1
2
Correct
3
To long staple
To short
Fig. 8
1
Fel
2
Fig. 9
1
Fig. 10
06.14